Short block rotating assembly parts

[Warbird89]

Well after a month of ownership with my new Trans Am with 14,000 original miles I did my first intermediate oil change found out the thing was three quarts low on top of that the oil look like pure silver, change the oil took it to my DMV put a hundred miles on the car and basically the bottom and grenades itself so yeah totally scammed on this car for 30 plus K but whatever should have known better so where is the best place to buy parts for the bottom end because if I'm doing this I'm doing it h Rod roller camshaft Etc

 

[TTA855]

My engine developed piston slap at 80K. I had it rebuilt by Cassell Engines in Spokane. My crank was fine. I replaced the pistons with forged JE .30 over (in hindsight forged might have been overkill for a street car). I replaced the cam with Comp Cams 206/206 roller (since it's a street car I didn't want to lose a lot of off boost throttle response).

 

[jarredsoon]

Dang
Tough break Warbird89, I am sure you will be back even better and then will have a killer low milage TTA