What's new
TurboTransAm.com

Register today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.

decal placement

Turbo TA MAN

Active Member
Does anyone know the correct placement for decals on the doors and windshield I have seen pictures of cars at indy with the decals in slightly differing placement on the doors,is there a published template or is it up to owner? [email protected]
Thanks, Bob
cwm3.gif


------------------
 
I looked all over the net but couldn't find one, so I looked at all the original ads that were published in a couple of mags I had, figured if it was good enough for the ad, it was good enough for me.
Looks like the lettering should start exactly under the front leading point of the door mirror. And be approximately 1 to 1.5 inch above the rubber edge guard.
This will make the lettering end about 2 inches before the door handle and just below it. Both sides the same.
That's where I put mine at least.

------------------
Rob
Rob's HIGH PERFORMANCE & PARTY page!
'89 TTA #426 bone stock
'87 Grand National 2nd owner 10 yrs.
40# inj,JL chip,HW Walbro 307,KB SS headers,THDP,V-4 IC, stock turbo & TC, SS dual exhaust, no cat.,Direct Scan, BFG 275/50/15 DRs on stock rims. Under 50K miles.
'95 Trans Am Convertible stock
'94 Silverado Tuned Port Injected
 
Back
Top