a-piller gauge pod

[ttarob]

Where's good place to get a 3 gauge a-piller pod? One that looks good in our cars? and will ship to Canada ?
Any help would be good, maybe one of you guys has a spare huh ?? $$

Thanks guys
Rob

 

[TC Turbo]

If I recall right mine is a Lotek 3 gauge. It's just a 3 gauge pod that you screw to the stock A pillar trim panel not the whole piller piece like is available for some cars. Some guys have said they got theirs from Summit too. Hope it helps.

 

[Jan Larsson]

I got the 2 gauge pillar pod from Lotek (see my install here http://www.tta1078.com/pillarpod2/index.htm) and was an ok fit but needed some work to look good ... cut off the top piece at the t-top for instance to make it fit properly ...

Autometer also do one but not sure about the fit ...

And some more photos of the Lotek one ... http://www.tta1078.com/pillarpod/

 

[ttarob]

thanks guys gives me a place to start anyway, I'd kinda like a full replacement style, incase I decide to go back to original. Don't want to look at screw holes, but I'll have a look.

Thanks
Rob

 

[Jan Larsson]

They all sit on top of the original pillar ... there is no replacement unfortunatly. Screw holes (or small rivets like I used) is the only way getting them to sit flush properly onto the OEM pillar piece.

 

[at t 2d]

I have the two pod Autometer and I am very happy with it. It mounts over the existing A pillar and covers all of it up to the molded in line near the ceiling. The only thing I don't like is the bottom pod puts a slight dimple in the dash because it sits a little low.

 

[WS6]

I have the two pod Autometer and I am very happy with it. It mounts over the existing A pillar and covers all of it up to the molded in line near the ceiling. The only thing I don't like is the bottom pod puts a slight dimple in the dash because it sits a little low.

I solved that by trimming the top of the pillar pod and moving it up 1/4". It also fits better on the A pillar now.